 |
 |
 |
|
|
 |
 |
MicroAIR Alternating Pressure Mattress MA55 w/on demand Low Air Loss
Economical alternating pressure mattress replacement system
The
microAIR APM provides pressure relief in the prevention and treatment
of pressure ulcers. This Group II support surface has a 250-lb weight
capacity.
This microAIR Alternating Pressure Mattress has 16
horizontally configured bladders. Mattress will not bottom out with
mattress hose attached to the compressor power unit.
This
alternating pressure mattress provides a temperate climate for patients
with its ability to circulate air within the mattress.
MicroAIR Control Panel:
MicroAIR Control Panel. Treatment times are 5, 10, 15, and 20 minute cycles.
Alternating Pressure Mode:
The
alternating pressure times indicate the frequency of deflation or
inflation of half of the air cushions (even or odd numbered). For
example, 10 minutes is selected. In this example, the even numbered air
cushions in the mattress will deflate, while the odd numbered cushions
remain at constant pressure. When 10 minutes has elapsed, the even
numbered air cushions will inflate while the odd numbered cushions
remain at constant pressure. When 10 minutes has elapsed again, the odd
numbered air cushions deflate while the even numbered cushions remain
at constant pressure. The air cushions continue to inflate or deflate
like this as long as an alternating pressure time has been selected. At
all times, half of the air cushions remain at a constant pressure when
an alternating pressure time has been selected.
Static Mode:
all air cushions in the mattress are maintained at constant pressure. The Static LED is illuminated GREEN.
Minimum Pressure Setting:
The
minimum pressure setting during Alternating Pressure is set to 0 (2
mmHg) at the factory. This means that the mattress will deflate as much
as possible during the deflation time when using 10, 15 or 20 minute
Alternating Pressure times. The setting can be changed so the mattress
will only deflate to 50% of the selected pressure setting.
MicroAIR Mattress:
The
waterproof cover is made of non-shear nylon and has nylon tie down
straps with buckles for attaching the mattress to the bed. The mattress
has a 16 bladders, each bladder is 6" thick. In addition, there is a 2"
foam safety pad under the nylon cover.
This MicroAIR mattress
has a non-skid bottom and is secured with 10 nylon web buckled
hold-downs. When rolled up for storage, carrying handles allow for easy
transport.
Standard Hospital/Homecare Bed Size:
Affordable with added comfort, this alternating pressure mattress is available in the standard 36" x 80" size (Twin XL). | |
|
|
|
|
|
|
|
|
|
